This guide will help with changing the camera dates and times. Once the cameras have been added to the dashboard, by default they will be named 'Camera Device'. Please follow the steps below:
1. Navigate to your Dashboard >click on Configure > Locations > Edit the location, then click on the camera tab as shown below:
2. Click on the desired camera you want to change, and click "Native Camera Config". Select Local if you are on-site and on the same network with the camera, otherwise click Remote and press Navigate Remotely
3. Once logged in, navigate to the Configuration tab > System > System Configuration tab > Time Settings
For new Spot cameras: Go to Setup >Time/date: Change as per your timezone and enable/set DST (daylight savings time) as well
Additional to the above step, you will need to enable OSD for the new Spot cameras
Navigate to setup > OSD and enable as following
4. Some cameras will auto-save changes, else make sure to save the changes!
We hope this article was useful to you, please leave us a comment or feedback as it will help us improve our customer support center.